Illustration with a professional applying the adhesion promoter for absorbent surfaces
Illustration with a professional applying the adhesion promoter for absorbent surfaces

MICROCEMENT PRIMER FOR NON-ABSORBING SURFACES MYPRIMER 200

Microcement finish in the kitchen of a house decorated in light, Nordic tones

MyPrimer 200 is a water-based acrylic primer that facilitates the adhesion of microcement on non-absorbent surfaces.

It is the recommended product for surfaces such as marble, terrazzo or tile. It consolidates the substrate and regularizes absorption allowing a good performance of the finishes.

Improves sealant adhesion on non-absorbing substrates and is ready to use. Its application is done by brush or roller.

Technical Characteristics

MyPrimer 200 - Secado al Tacto

Dry to Touch
Between 30 and 60 minutes depending on environmental conditions

MyPrimer 200 - pH

pH
between 8 and 9

MyPrimer 200 - Viscosidad

Viscosity
12-13 s (Ford Cup 4)

Performance

MyPrimer 200

(1 coat) 0.09 L/m2

Color jug of MyPrimer 200 primer

Application of MyPrimer 200

1

Imprimación Microcemento Superficies No Absorbentes

SURFACE PREPARATION

MyPrimer 200 is a high-quality ready-to-use product that can only be applied on a support that must be stable, clean, dry, dust-free, grease-free and without loose parts.

2

Choosing the right roller

SECURE THE SURFACE

For an effective application of this adhesion promoter, the support must be free from remains of self-leveling and chemical products.

3

Choosing the right roller

RESPECT THE DRYING TIMES

The surface should be dimensionally stable enough. For proper preparation of the subfloor, it should be allowed to dry between 30 minutes and 24 hours before applying the first layer of microcement.

4

Choosing the right roller

THE IMPORTANCE OF TEMPERATURE

At low temperatures and high humidity, the primer drying process may take longer. It is advisable to apply the primer at an ambient temperature between 10 and 30ºC.