MyMetal is a two-component metal coating made to obtain a shiny finish on non-walkable surfaces. It has an A component, formed by metal powder particles, and a B component, which is a resin designed for this coating.
It has finishes in iridium, aluminum, bronze, copper and brass. Applicable with trowel and roller to achieve different finishes.
It is possible to achieve oxidized finishes with the use of the MyRust rust activator.
High shine
High concentration of metallic components
Applicable on any non-walkable surface.
Microcement, concrete, brick, ceramic, etc.
Different textures
Five textures with different metallic elements
Maximum thickness per layer
1mm
1. Cleaning of the surface
Before applying MyMetal, you
must ensure that the
support is clean and dry.
To ensure a total clean of the space, it may be necessary
to vacuum.
2. Support preparation
Apply a layer of primer MyPrimer 100, if it is an absorbent surface, or MyPrimer 200, if it is a non-absorbent support.
3. Mix components A and B
Mix component A and B.
Apply 2 layers of Mymetal
on the support.
1st layer dry for 2 hours*.
2nd layer dry for 12 hours*.
4. Sanding and cleaning to bring out metallic shine
Sand the surface with a sandpaper
with grain of 180-220.
Polish with a sandpaper of grain
800 and 1000.
This is how the
metallic shine is obtained.
Clean to remove dust.
5. Sealing the surface
To achieve a metallic
finish, two layers of the
sealant varnish
MySealant 2K. must be applied.
1st coat: Dry 24 hours*.
2nd coat: Dry 24 hours*.
*Drying times may vary depending on environmental and temperature conditions.
