MyPrimer 100 is the proper primer for absorbent surfaces such as plaster or plasterboard. It is very effective due to the ability of penetration and the packaging is ready to use.
It is a water-based acrylic dispersion and only one coat is needed. It can be applied by brush or microfibre roller.
MyPrimer is a quick-drying adhesion promoter with which the surface will be ready for the application of microcement in just 30 minutes.
This product penetrates perfectly into the absorbent substrate and has a white colour that will become colourless when dry.
Dry to Touch
Between 30 and 60 minutes depending on environmental conditions.
pH
between 8 y 9
Viscosity
10-11 s (Copa Ford 4)
MyPrimer 100
0,10 L/m2
1
Before applying the primer, the substrate must be dry and free of grease, oil and dust.
2
3
It is better to carry out in a well ventilated space with a temperature between 10 and 30ºC. Aplicatores should wear rubber gloves and safety glasses to protect against possible splashes.
MyPrimer 100 is free of solvents or plasticisers.
4
To get the most out of the product, the lid should be closed after each use.
This is a good way to prevent from drying.